TBD Black Magic ATEM Raspberry Pi Tally

Third Party Software designed for Black Magic Atems
jmvb
Posts: 8
Joined: Wed Aug 15, 2018 4:53 pm

Re: TBD Black Magic ATEM Raspberry Pi Tally

Post by jmvb » Thu Oct 04, 2018 12:54 am

Testing if this model of raspberry will work

Image

Punkley
Site Admin
Posts: 26
Joined: Tue May 29, 2018 2:22 pm

Re: TBD Black Magic ATEM Raspberry Pi Tally

Post by Punkley » Thu Oct 04, 2018 12:57 am

it boots up, so it should work :)

Kingsley

jmvb
Posts: 8
Joined: Wed Aug 15, 2018 4:53 pm

Re: TBD Black Magic ATEM Raspberry Pi Tally

Post by jmvb » Thu Oct 04, 2018 1:01 am

Punkley wrote:
Thu Oct 04, 2018 12:50 am
it doesn't run X so startx will never work :)

what are you trying to do?

Sorry, I know nothing about Raspberry

The atem is not connected to the device, just testing the booting

What I need to do to run X?

Punkley
Site Admin
Posts: 26
Joined: Tue May 29, 2018 2:22 pm

Re: TBD Black Magic ATEM Raspberry Pi Tally

Post by Punkley » Thu Oct 04, 2018 1:08 am

to get the tally running you don't need to run X

at the ssh prompt just login as tally-config

jmvb
Posts: 8
Joined: Wed Aug 15, 2018 4:53 pm

Re: TBD Black Magic ATEM Raspberry Pi Tally

Post by jmvb » Thu Oct 04, 2018 1:36 pm

Punkley wrote:
Thu Oct 04, 2018 1:08 am
to get the tally running you don't need to run X

at the ssh prompt just login as tally-config
I need to do that everytime that the system is powered?

Punkley
Site Admin
Posts: 26
Joined: Tue May 29, 2018 2:22 pm

Re: TBD Black Magic ATEM Raspberry Pi Tally

Post by Punkley » Thu Oct 04, 2018 1:40 pm

no, it will configure it to your atem settings and then the gpio should start working. so it comes down to adding led lights.

Kingsley

Post Reply